top of page
1. Cut a piece of P-Plast of the required size, separate the protective film from the back side.
image003_edited.jpg
 2. Stick a piece of P-Plast on the  pressure plate opposite the die.
image004_edited.jpg
 3. Ride the machine under pressure several times until a clear image on the P-Plast is formed.
image005_edited.jpg
4. Cut the P-Plast along the contour of the resulting image. Remove excess film. Seal the image with tape to stabilize the counter die.
image006_edited.jpg
скрепка.png
Keep the embossing pressure as low as possible -
if there is an excess of pressure, the counter die may shift.
bottom of page